JANDY | HEAT EXCHANGER COMPLETE,125 | 10606401

JANDY | HEAT EXCHANGER COMPLETE,125 | 10606401

part for models : MFG 2003 - PRESENT

OPTIMUS # 6203-041 JANDY # 10606401 GENERAL DESCRIPTION: THIS IS THE COMPLETE HEAT EXCHANGER USED IN THE TELEDYNE / JANDY 125 HEATER THIS INCLUDES THE REAR HEADER AND THE FRONT HEADER USED IN THESE MODELS XE MODELS EG, ES, ES-II, EC SERIES 1 MODELS EPG, EPM, EPC SERIES 2 MODELS ESG, ESC LITE MODELS LLD, LLG, LLC LITE2 MODELS LD, LG, LC, LJ NOTE THAT THE FRONT HEADER IS PART NUMBER R0056400 FOR USE WITH THE 2" FLANGES THE ACTUAL OPENINGS IN THE FRONT HEADER ARE ABOUT 2-1/4" IN DIAMETER SOME MUCH OLDER XE AND SERIES 1 MODELS USED 1-1/2 FLANGES IF THE ORIGINAL HEATER USED 1-1/2" FLANGES, THE FLANGES AND GASKETS WILL NEED TO BE REPLACED ALSO NUMBER OF TUBES: 9 THESE ARE STAGGERED WITH 5 ON BOTTOM AND 4 ON TOP TOTAL LENGTH: 18" (APPROXIMATE - FROM OUTSIDE OF FRONT HEADER TO OUTSIDE OF REAR HEADER) TOTAL HEIGHT: 7-1/4" (APPROXIMATE - THIS IS THE HEIGHT OF THE FRONT HEADER) TUBE BUNDLE LENGTH: 9-7/8" (LENGTH FROM OUTSIDE OF ENDPLATE TO OUTSIDE OF ENDPLATE) TUBE BUNDLE HEIGHT): 3" (END PLATE HEIGHT) WIDTH: 14-1/4" (MEASURED ON THE ENDPLATE - BASICALLY THIS IS HOW LONG THE ENDPLATE IS) ITEMS INCLUDED WITH THE TUBE BUNDLE THE HEAT EXCHANGER ASSEMBLY IS ALREADY COMPLETELY ASSEMBLED WITH THE FOLLOWING ITEMS (1) FRONT HEADER - R0056400, 2" CAST IRON (INCLUDES 3/4" PLUG IN TOP, PRESSURE SWITCH ATTACHMENT FITTING SCREWED IN, AND COMPLETE BYPASS ASSEMBLY, GASKET, AND CAP PRE-INSTALLED) (1) REAR HEADER - R0058300, CAST IRON (INCLUDEDS 3 PRE-INSTALLED BRASS PLUGS, 1 IN TOP AND 2 IN THE END (1) COMPLETE SET OF HEADER GASKETS (18 TOTAL) (1) BAFFLE KIT (8 BAFFLES) (1) BAFFLE RETAINER (8) HEADER NUTS, BOLTS, AND WASHERS (ENOUGH TO MOUNT BOTH HEADERS) SPECIAL NOTE - FLANGES AND FLANGE GASKETS ARE NOT INCLUDED